DCD Designs Detectable Ruf Rod Dlx Duct Rodder 5/sixteen” X 200′ 53700-200

Light Cast\/Troll Jared Johnson Fiberglass Team Kokanee Casting Rod ...DCD Designs Detectable Ruf Rod Deluxe Duct Rodder 5/16″ X 200 Ft. 53700-200

Detectable Ruf Rod Duct Rodder

vintage heddon vintage heddon 1387 fiberglass fly 8 6 rod line 8 made ...53700 Sequence 5/sixteen” Diameter

The DCD Designs 5/sixteen” Ruf Rod Duct Rodder is considered one of the most popular sizes because of its versatility in each small and medium dimension ducts. It’s the smallest of the wheel frames, but still nicely underneath 3 ft. in height or size so easy to retailer or load onto your truck.

Though DCD solely recommends lengths as much as 600 ft., the standard cage will hold up to 800 ft.

The longer lengths should only be utilized in smaller ducts (up to 2-1/2″dia) and when there are few bends.

The standard unit features a feminine rod finish, a swivel rod finish and a pulling eye.

This deluxe version consists of:

The standard unit without the equipment is denoted by the “Xafter the half number

DETECTABLE DUCT RODS

DCD Detectable Duct Rodders can be found in 3/16 5/16and 7/16diameter rods.

They are available in the same lengths because the regular duct rodders and are mounted in the same frames.

The aim of the DCD Designs Detectable Duct Rod is to be able to precisely find present ducting underground or to locate the position of a blockage inside a duct.

Every DCD Detectable duct rod unit is equipped with a terminal box mounted on the body with male and female banana terminals for external hook up.

It is recommended that a DCD Designs Roller Guide (57150 collection) all the time be used so as to higher make the connection between the tip of the rod and the wall of the ducting.

This is critical in order to complete the circuit back to earth. Any transmitter can then be hooked up to the terminal box with the second lead from the transmitter going to ground (spike into earth). Once switched on, the sign will

be transmitted along the duct rod and a typical locator can then be used to locate the signal supply from above floor.

DCD Also gives various stainless steel adapters for attaching a sonde unit to the swivel rod finish.

The DCD Designs Detectable duct rodders use 22 gauge copper wire.

Warning ought to be exercised when ordering lengthy lengths as a result of the signal will diminish with distance traveled.

Excessive Danger: Never use a DCD Designs Detectable Duct Rodder in a live electrical surroundings. Electrical shock or loss of life could outcome if conductive rod touches uncovered circuit.

Chandler Gear Sales has been promoting new and used building instruments and gear for 25 years. We’re Authorized Distributors for DCD Design and plenty of different manufacturers.

Leave a Reply

Your email address will not be published. Required fields are marked *